TMS zl Module Release Notes ST.1.0.090213

Known Issues

Release ST.1.0.090213

■ PR_0000007914 — The TMS zl Module Web browser interface is designed to only have one

client logged in as manager at any given time to avoid one manager's changes overwriting

another manager's changes. In most cases, this works as expected. However, multiple clients

can log in as manager by following the steps below.

1. Using the Web browser interface, login as manager on the TMS zl Module.

2. Connect to the Web browser interface page on a second client.

3. Login as manager. The TMS zl Module prompts to interrupt current manager, click cancel.

4. This brings up the logout prompt (Save&Logout, Do Not Save& Logout, Cancel), click Cancel.

Now, the additional client is logged into the Web browser interface as manager.

■ PR_0000008044 — The TMS zl Module has been configured for VLAN IP addresses and HA

is enabled but unconfigured (that is, there is only one device in the cluster). If HA is

subsequently disabled, the VLAN IP addresses are lost. This could result in a loss of

management connectivity.

■ PR_0000008136 — Only 1,000 NAT Policies are supported on the TMS zl Module. The TMS

zl Module incorrectly accepts more than 1,000 NAT policies. These NAT policies work fine,

but they should not be used as a future software release may restrict the NAT policies. Please

keep the number of NAT policies used to 1,000 or fewer.

■ PR_0000008274 — The log entry that is logged when a new access policy is added has the

wrong zone information. Refer to the following log sample:

time="2008-08-14 10:54:36" severity=info pri=6 fw=ProCurve-TMS-zl-Module

id=config_configuration ruleid=123 msg="IAPPOL: adding new IA Policy record

" srczone=SELF dstzone=SELF result=0 throttledcount=20 subfamid=configura-

tionchanges operation=0 mtype=config mid=697

IA Policy refers to an Internet Access Policy, but both zones are indicated as "SELF" which is

incorrect.

■ PR_0000008428 — Multicast routing is enabled after adding or editing multicast on a VLAN

and refreshing the screen. If multicast routing is going to be configured and disabled until a

later time, the user should always disable multicast routing as the last step, after configuring

VLAN Settings.

Here is an example of the issue:

1. Launch the TMS zl Module’s Web browser interface.

2. Go to the Network section.

3. Select the Routing.

4. Go to the Multicast tab.

5. Under Multicast Settings, disable Multicast Routing by unchecking the box next to Enable

multicast routing.. Click the Apply My Changes button.