TMS zl Module Release Notes ST.1.0.090213
14
Known Issues
Release ST.1.0.090213
1. Open a Web browser interface session.
2. Go to Network > Zones > VLAN Associations.
3. Add two or three VLAN Associations.
4. Open a CLI session with the TMS zl Module via the switch,
ProCurve Switch# services d 2
5. Display VLAN information by using the show vlans command.
■ PR_0000013220 — When a software update is performed by retrieving the image via FTP,
SCP, or TFTP, a generic error message is displayed for any user input error. For example, if
the IP address is incorrect, if the username is wrong, or if the password is wrong, the error
message simply indicates a failure and does not call out the specific problem.
■ PR_0000013324 — In the TMS zl Module CLI, the Help text for the copy command needs
to be updated. For example, the following command reveals incorrect help text.
ProCurve Switch (tms-module-D)# copy ftp image help
■ PR_0000013391 — An error is produced when removing VLAN 1 from a TMS zl Module
Zone:
HPESP: Services zl Module C: unable to create VLAN. Configuration
error
. To reproduce this, start with a default switch configuration where all TMS zl Module
ports are untagged in VLAN 1 by default. Then, from the TMS zl Module’s CLI, use a command
similar to: vlan 1 zone external allow-switch-ip. At this point, type no vlan 1. The above error
message is displayed in the switch event log.
■ PR_0000013539 — In the TMS zl Module CLI, the software update commands will accept
the "\" character and ignore it as input for the username and filename. Therefore, valid
usernames or valid filenames that are made invalid by the addition or insertion of a "\"
character in their names are accepted as valid because the "\" characters are simply ignored.
The software update functionality in the Web browser interface has the same issue.
■ PR_0000013560 — When a user is in a TMS zl Module CLI session and they copy the
startup-config file to an FTP server when the ALG for FTP is disabled, the copy command
appears to hang. After about 60 seconds, the copy command will timeout and the user session
can be recovered.
Example:
1. Open a TMS zl Module CLI session.
2. Disable alg ftpv4
ProCurve Switch (tms-module-D:config)# no alg ftpv4