TMS zl Module Release Notes ST.1.0.090213

Known Issues

Release ST.1.0.090213

rate or count drops, the state is transferred correctly. However, should a failover from the

Master to the Participant occur at the time when TCP state information cannot be sent, there

will be an additional failover delay as applications re-establish their TCP state with the

Participant (now the Master after the failover).

Monitor Mode Only

■ PR_0000005928 — When in Monitor Mode, a scan of the open ports will reveal TCP port

616 and TCP port 9999 as being open. The only way to block these ports is to setup a firewall

access policy to restrict them.

■ PR_0000007533 — If the TMS zl Module is in monitor mode, the IDS logs incorrectly show

zones Internal and Zone6 in the logs for data and management. These zone references are not

correct and should be ignored.

■ PR_0000011929 — When in monitor mode and using the TMS zl Module CLI, if you add

an management IP address, the CIDR format of IP-Address/mask is not accepted and you

must enter the IP address and Subnet Mask as separate values.

■ PR_0000014582 — In monitor mode, the CLI command ips help does not reflect the

commands that are actually available in monitor mode as opposed to routing mode.

■ PR_0000015755 — In monitor mode, the management VLAN can be deleted from the

switch. In routing Mode, the user is prevented from making this change on the switch.

Example:

Preconditions: monitor mode, management VLAN and management IP address have been set. In

this example, the management VLAN is 30.

Delete the management VLAN from the switch CLI.

ProCurve Switch (tms-module-D:config)# no vlan 30

An error message should be displayed preventing the deletion of the VLAN due to its use by the

TMS zl Module. A user is not prevented from performing this action and the VLAN is deleted. As

a result, the Web browser interface of the TMS zl Module can't be accessed because the

management VLAN has been deleted

■ PR_0000017758 — In monitor mode, when IPS full inspection is turned on and the FTP

ALG is turned off, sending an FTP copy of the startup configuration to the network fails with

a broken pipe error.