TMS zl Module Release Notes ST.1.1.100330

21
Software Fixes in Releases ST.1.0.090213 - ST.1.1.100330
Release ST.1.1.100226
■ PR_11856 — When using the Web browser interface, an error message is displayed when a
valid IP Address is trying to be set in some pages, such as RADIUS, IPsec Policies, and so
forth. For example, this may occur when an otherwise valid IP address is added with a final
space at the end.
■ PR_12802 — When adding an NSSA or STUB area to the OSPF configuration, leading zeros
in the area ID are flagged as an error. For instance, 10.10.01.10 would not be accepted but
10.10.1.10 would be accepted.
■ PR_12838 — Using SNMP, the values of system name, contact, and location via the RFC
1213 system table cannot be changed.
■ PR_14783 — When moving a TMS zl Module from one switch to another, DHCP Relay may
not start if there is a mismatch in VLAN configuration between the switches. Specifically, if
a VLAN is enabled in DHCP Relay and then the TMS zl Module is moved to another switch
which doesn't have that VLAN, the DHCP Relay agent doesn't start up and DHCP Relay will
not work. When moving a TMS zl Module, if you wish to maintain the TMS zl Module
operation, be sure the VLAN information matches before moving the module to another
switch.
■ PR_15477 — When adding and removing VLANs via the CLI, additional log messages are
created that are not created when using the Web browser interface to add and remove VLANs.
■ PR_15522 — There is a difference in how the timezone information is displayed in the TMS
zl Module as compared to the switch. The TMS zl Module follows the POSIX standard for
displaying the time, for example, GMT+6 is displayed to indicate the timezone. However, the
switch uses a negative number to set the timezone. The time is correctly displayed in both
cases, but the process to set the timezone may cause some confusion.
■ PR_15547 — In PCM, the Add/Delete of a trap receiver may fail due to the TMS zl Module’s
SNMP agent's response delay.
■ PR_16102 — In PCM, neighbor network mapping between the TMS zl Module and 5400/8200
chassis is not properly done. The TMS zl Module added LLDP functionality based upon the
priority VLAN to correct the mapping.
■ PR_16812 — Password authentication failure traps were missing the originating IP address
and username for which the password authentication failure was occurring
■ PR_16892 — When the local log contains more than 10,000 entries, the oldest entries (after
the 1,000th entry) are displayed in a wrong position.
Steps to reproduce:
1. Get more than 10,000 entries in the local log.
2. Either export the local log or, in the Web browser interface, set the number of entries per
page to 500 and go to page 6.