TMS zl Module Release Notes ST.1.1.100330

27
Known Issues
Release ST.1.1.100226
■ PR_ 39670 — LLDP protocol sends localhost as the name of the system instead of configured
hostname in monitor mode.
■ PR_41166 — In the routing CLI, ip rip send should work as enabling sending updates.
■ PR_41291 — In the CLI, show logging local filter date-time accepts invalid time values.
■ PR_42142 — When using the Firefox browser, when on the Update Software page and
refreshing or going to a different tab, the following message is displayed Can't establish
connection with the device. The message is displayed only for a few moments. In
IE7, this message is not displayed.
■ PR_42607 — In the Web browser interface, duplicate IP addresses are allowed under DNS
configuration. The Web browser interface allows you to put the same IP address twice, under
Primary DNS server and Secondary DNS server.
■ PR_42753 — In the TMS zl Module CLI, the show ip command's output has domain
misspelled as Dommain.
■ PR_42760 — The TMS zl Module SNMPv3 server only supports security level authPriv for
SNMPv3 users.
■ PR_42887 — Changing the hostname in the Web browser interface does not change the
hostname in the CLI immediately. A current user of the CLI must logout and log back in again
to see the change reflected in the prompt. A CLI user can see the updated hostname in
show run even though the prompt is still the old hostname.
■ PR_42971 — RADIUS authentication will attempt to authenticate to local users if the user
name is entered without a domain or organization. This method of authenticating users is
documented but is very different from RADIUS authentication on ProCurve switch platforms
and could result in confusion.
■ PR_43321 — TMS zl Module is generating log entries with UNKNOWN_ZONE when a RADIUS
user is authenticated by a RADIUS server.
■ PR_43540 — The CLI commands ips web-proxy help and ips web-proxy ? output text do not
explain that a separate command ips web-proxy is required to enable the proxy.
■ PR_43546 — With PIM disabled, if a user sets up a a rendezvous point, PIM is automatically
enabled without notifying the user.
■ PR_43612 — copy pcap should be copy capture to be consistent with capture command.
■ PR_43806 — If a user wants to remove the management vlan and IP from monitor mode,
there is no command to do that. Work Around: Erase the startup configuration and reboot.
■ PR_44131 — For RIPv1, how classful static routes and host routes (/32) are summarized
differs between TMS zl Module and the 5400/8200 series switches.