TMS zl Module Release Notes ST.1.1.100330

43
Known Issues
Release ST.1.0.090603
■ PR_52480 — In SCEP Settings, a user cannot clear the unique CA identifier field, either
through the Web browser interface or the CLI interface. If a user fills in all the text fields in
the SCEP settings except for the Unique CA Identifier, then presses Apply My Changes, no error
is thrown and the settings are applied successfully. When the user clicks the SCEP tab again,
the Unique CA Identifier contains the string "scep".
■ PR_53488 — TMS zl Module GRE functionality may not properly detect GRE keep-alives if
a non-TMS endpoint specifies GRE options such as Checksums or Sequencing. Normal GRE
traffic can be received with these options present, but GRE keep-alives with these options
are not handled properly. This results in the GRE tunnel being detected as down by the
non-TMS endpoint of the GRE tunnel. Please note that the TMS zl Moule does not at the
present time include the capability of specifying GRE options such as these, so they cannot
be configured for transmission of GRE traffic from the TMS zl Module. Also note, some GRE
implementations allow for a key parameter to be specified. The TMS does not allow for a
key configuration item. If a GRE implementation has the key parameter specified, normal
GRE traffic as well as keep-alive traffic will not pass.
Release ST.1.0.090603
The following problems are known issues as of release ST.1.0.090603.
Upgrading to ST.1.0.090603 from ST.1.0.090213
PR_41849/PR_41855 — After upgrading, the switch command line reports the first installed TMS
zl Module software version (ST.1.0.090213) rather than the updated version (ST.1.0.090603)
When the TMS zl Module is running ST.1.0.090213, the following behavior is observed:
The output of the switch CLI command, show services <slot-ID> detail, and the output of the TMS zl
Module CLI command, show version, are both correct.