TMS zl Module Release Notes ST.1.1.100330

Known Issues

Release ST.1.0.090213

The first syslog server is deleted and there is no way to specify the second syslog server except

to execute the no logging syslog 192.168.1.59 command again.

■ PR_5390 — The administrator cannot change the password for MD5 authentication on an

OSPF interface without knowing the previous password. As a workaround, first disable the

VLAN from OSPF and then re-enable it with the new password.

■ PR_6127/ PR_16218 — The output of the show run command will show an FDPoll

Returned Error message, which is not relevant to the output and inconsequential. It can

safely be ignored.

■ PR_7300/PR_7303 — From the CLI, the logging command does not auto-complete when

the Tab key is pressed as other commands from the command line do. As a result, the user

must fully type the parameter needed.

For example, the following commands do not auto-complete to enable when the Tab key is

pressed after only en is typed:

ProCurve Switch(tms-module-D:config)# logging syslog en

ProCurve Switch(tms-module-D:config)# logging snmpv2 en

ProCurve Switch(tms-module-D:config)# logging snmpv3 en

■ PR_7394 — A vague message is displayed when the maximum number of users have already

been added to a group and an administrator attempts to add another user to the group.

CLI:

Error: Failed to add user group: 88

Web browser interface: The user could not be added.

■ PR_7723 — In the TMS zl Module CLI, an error message should be displayed and the entry

rejected when an invalid mask value is used for IP Address/Mask when specifying an IP

address for a VLAN. The user must carefully validate their input.

In the following example the incorrect mask value may result in the wrong subnet mask being

used:

ProCurve Switch(tms-module-D:config)# vlan 1 ip address 192.168.11.25/2254

Success: Set VLAN 1 IP address to: 192.168.11.25 255.255.252.0

■ PR_7740 — During a UDP flood, the log incorrectly refers to it as a TCP flood by using

tcpconnectionanomaly. As a result, the administrator will not know whether a UDP flood

is occurring or a TCP flood is occurring.

■ PR_7914 — The TMS zl Module Web browser interface is designed to only have one client

logged in as manager at any given time to avoid one manager's changes overwriting another

manager's changes. In most cases, this works as expected. However, multiple clients can log

in as manager by following the steps below.

1. Using the Web browser interface, login as manager on the TMS zl Module.

2. Connect to the Web browser interface page on a second client.