TMS zl Module Release Notes ST.1.1.100330

Known Issues

Release ST.1.0.090213

3. Login as manager. The TMS zl Module prompts to interrupt current manager, click cancel.

4. This brings up the logout prompt (Save&Logout, Do Not Save& Logout, Cancel), click Cancel.

Now, the additional client is logged into the Web browser interface as manager.

■ PR_8044 — The TMS zl Module has been configured for VLAN IP addresses and HA is

enabled but not configured (that is, there is only one device in the cluster). If HA is

subsequently disabled, the VLAN IP addresses are lost. This could result in a loss of

management connectivity.

■ PR_8136 — Only 1,000 NAT Policies are supported on the TMS zl Module. The TMS zl Module

incorrectly accepts more than 1,000 NAT policies. These NAT policies work fine, but they

should not be used as a future software release may restrict the NAT policies. Please keep

the number of NAT policies used to 1,000 or fewer.

■ PR_8274 — The log entry that is logged when a new access policy is added has the wrong

zone information. Refer to the following log sample:

time="2008-08-14 10:54:36" severity=info pri=6 fw=ProCurve-TMS-zl-Module

id=config_configuration ruleid=123 msg="IAPPOL: adding new IA Policy record

" srczone=SELF dstzone=SELF result=0 throttledcount=20 subfamid=configura-

tionchanges operation=0 mtype=config mid=697

IA Policy refers to an Internet Access Policy, but both zones are indicated as "SELF" which is

incorrect.

■ PR_8428 — Multicast routing is enabled after adding or editing multicast on a VLAN and

refreshing the screen. If multicast routing is going to be configured and disabled until a later

time, the user should always disable multicast routing as the last step, after configuring VLAN

Settings.

Example:

1. Launch the TMS zl Module’s Web browser interface.

2. Go to the Network section.

3. Select the Routing.

4. Go to the Multicast tab.

5. Under Multicast Settings, disable Multicast Routing by unchecking the box next to Enable

multicast routing.. Click the Apply My Changes button.

6. Multicast routing is disabled.

7. Add or edit a VLAN with Multicast enabled.

8. Refresh the Multicast page by pressing F5.

9. Multicast routing is now enabled (the box next to Enable multicast routing.. is checked).

Expected Result: Multicast routing should remain disabled.