TMS zl Module Release Notes ST.1.1.100330
61
Known Issues
Release ST.1.0.090213
Example:
1. Log in as an operator.
2. Go to Maintenance > Update Software > Server Type drop down selection box.
or
Go to Authentication > RADIUS > Protocol drop down selection box.
■ PR_12250 — In environments where high connection rates and high connection counts
are in use, management interfaces can be slow or locked up. This will occur when the
administrator has not specified a Priority VLAN for management in their configuration. A
Priority VLAN ensures that the administrator will always have management access from the
specified VLAN.
■ PR_12607 — ICMP replay will generate a log entry even when the setting is disabled.
■ PR_12802 — When adding an NSSA or STUB area to the OSPF configuration, leading zeros
in the area ID are flagged as an error. For instance, 10.10.01.10 would not be accepted but
10.10.1.10 would be accepted.
■ PR_12838 — Using SNMP, the values of system name, contact, and location via the RFC
1213 system table cannot be changed.
■ PR_12937 — In a certain condition, when the TCP RST timeout value is set to zero and
IPS is enabled, the TMS zl Module will not forward a TCP RST packet from one peer to
another. If there is a TCP session established or half-established between client and server,
and the server sends an RST Packet to close the session, the TMS zl Module will mark the
session to be deleted. If IPS is enabled, the TMS zl Module will forward the RST packet to
IPS. After IPS finishes processing the packet, the TMS zl Module gets the RST packet. Since
TMS zl Module has already marked the session to be deleted and the RST timeout value is 0,
the RST packet is not forwarded to the peer and is dropped. The problem only happens for
RST packets. By setting the RST timeout value to something other than zero, this issue can
be avoided.
■ PR_13105 — When using the show vlans command in a CLI session established by going
through the switch interface, the VLAN information displayed is overlapped.
Example:
• MGMT VLAN has been added.
DNS Server, default gateway and domain suffix have been added.
1. Open a Web browser interface session.
2. Go to Network > Zones > VLAN Associations.
3. Add two or three VLAN Associations.
4. Open a CLI session with the TMS zl Module via the switch,
ProCurve Switch# services d 2