Wireless Edge Services xl Module Release Notes WS.02.27

15
Support Notes
Release WS.02.07
If the server does not send the proper VSAs, the user receives the monitor role (read-only) to the
Web browser interface.
The module’s internal server does not support VSAs, so you should use the local server only to
authenticate users that require read-only access.
Note
If you do not correctly configure the RADIUS server, you can lock yourself out of the Wireless Edge
Services xl Module Web browser interface.
To fix the problem, access the module CLI through the wireless services-enabled switch. Enter this
global configuration mode command to have the module authenticate Web-Users against its local list:
Syntax: aaa authentication login default local
Then configure at least one user in the local list:
Syntax: username <username> password <password>
The password must be between 8 and 32 characters.
Then assign the user rights sufficient to correct the problem. For example:
Syntax: username <username> privilege superuser
Special Characters for the ACL ID Field
As indicated in the chapter “Access Control Lists (ACLs)” of the Management and Configuration
Guide (5013-5912, May 2007), string names for ACL IDs may contain alphanumeric characters, but
spaces and non-alphanumeric characters are not allowed. However, the following special characters
may be used:
` ~ ! @ # $ % ^ & * ( ) _ - { } [ ] | : ; ' < > , .
Correction: SNMP v3 Default Password
The chapter “Configuring the ProCurve Wireless Edge Services xl Module” of the Management and
Configuration Guide (5013-5912, August 2007), pages 2-117 and 2-120, incorrectly states that for the
snmptrap user, the default password is “procurve”. Instead, the default password is “trapuser.”
Correction: Stations per Radio
The xl Module's Management and Configuration Guide (August 2007), page 1-4, incorrectly states
that each RP radio can support up to 64 stations simultaneously. Beginning with software version
WS.02.xx, the correct number of local stations per radio is 256.