Wireless Edge Services xl Module Release Notes WS.02.27
Table Of Contents
- Release Notes: Version WS.02.27 Software for the ProCurve Wireless Edge Services xl Module (J9001A) and the ProCurve Redundant Wireless Services xl Module (J9003A)
- Copyright and Disclaimers
- Contents
- Software Management
- Support Notes
- Release WS.02.07
- Reconfigure Management Passwords After a Software Update from Version WS.01.xx to Version WS.02.xx
- Accessing the Web Browser Interface After a Software Update from Version WS.01.xx to Version WS.02.xx
- Configuring Authentication for Web-Users
- Special Characters for the ACL ID Field
- Correction: SNMP v3 Default Password
- Correction: Stations per Radio
- Correction: Stations per Module in a Layer 3 Mobility Domain
- Correction: Disabling TKIP Countermeasures
- Clarification: Setting Intrusion Detection with TKIP Countermeasures
- Release WS.02.07
- Enhancements
- Software Fixes
- Known Software Issues and Limitations
- Back Cover
17
Enhancements
Release WS.01.11 Enhancements
Enhancements
Unless otherwise noted, each new release includes the enhancements added in all previous releases.
Enhancements are listed in chronological order, oldest to newest software release. To review the
latest enhancements since the last general release, see “Release WS.02.26 Enhancements” on page 21.
Release WS.01.11 Enhancements
Release WS.01.11 includes the following enhancements:
■ Time zone software now complies with the United States Energy Policy Act of 2005. Under
the new law, Daylight Saving Time begins the second Sunday of March and ends the first
Sunday of November.
■ Effective July 20, 2007, new FCC regulations on the use of the 5GHz band, the band used by
radios supporting the IEEE 802.11a standard, prohibit the sale of radios not meeting the new
specifications. To comply with these new requirements, WS.01.11 disables channels 52, 56,
60, 64 (5.25-5.35 GHz) in the U.S. These channels remain available for use in other countries.
■ The restricted management access feature specifies a single interface (VLAN) for
management access to a Wireless Edge Services xl module. SNMP access or access to the
module’s Web browser interface is only available on the specified restricted management
VLAN. By default, this feature is not enabled.
To display the current management VLAN, use the show management command from the module’s
CLI. In the example below, the default, not restricted, management VLAN is displayed.
ProCurve(wireless-services-A)#show management
Mgmt Interface: vlan1
Management access permitted via any vlan interface
ProCurve(wireless-services-A)#
Note:
If you change the management VLAN to a VLAN other than VLAN 1, be sure to enter a default
route that is within the subnet associated with the new management VLAN. See the Management
and Configuration Guide for information on how to add a default route.