Wireless Edge Services xl Module Release Notes WS.02.27
Table Of Contents
- Release Notes: Version WS.02.27 Software for the ProCurve Wireless Edge Services xl Module (J9001A) and the ProCurve Redundant Wireless Services xl Module (J9003A)
- Copyright and Disclaimers
- Contents
- Software Management
- Support Notes
- Release WS.02.07
- Reconfigure Management Passwords After a Software Update from Version WS.01.xx to Version WS.02.xx
- Accessing the Web Browser Interface After a Software Update from Version WS.01.xx to Version WS.02.xx
- Configuring Authentication for Web-Users
- Special Characters for the ACL ID Field
- Correction: SNMP v3 Default Password
- Correction: Stations per Radio
- Correction: Stations per Module in a Layer 3 Mobility Domain
- Correction: Disabling TKIP Countermeasures
- Clarification: Setting Intrusion Detection with TKIP Countermeasures
- Release WS.02.07
- Enhancements
- Software Fixes
- Known Software Issues and Limitations
- Back Cover
28
Software Fixes
Release WS.02.12
■ Wireless (41324) — Access point detection requires that either the Single channel scan for
Unapproved APs or Dedicate this Radio as a Detector is enabled in the radio configuration, but
Single channel scan for Unapproved APs has no affect if the Self Healing feature is enabled. With
this fix, rogue radios no longer show up when a radio port is part of a self-healing group
unless single channel scan is enabled.
■ Wireless (41389) — The ProCurve IDM QoS setting is not being applied in the proper
direction.
■ Wireless (41482) — When devices using power save mode re-associate with a radio port,
they may have connectivity issues. When this happens to SVP phones, the phones will display
a message similar to Unable to contact PRI gateway when they try to re-associate.
■ Wireless (41320) — The TIM bit (in the wireless beacon) is not getting cleared when SVP
phones in power save mode re-associate.
■ Wireless (41711) — Wireless stations should be allowed to transmit and receive data
directly following a 4-way WPA handshake, rather than waiting for the 2 message group key
handshake messages afterward. This causes communication failure in certain clients.
■ Wireless (41341) — Rogue AP detection continues to detect unapproved AP's even when
AP detection and (self-healing) scanning are both disabled.
Release WS.02.12
Problems Resolved in Release WS.02.12
■ Applet (42774) — The Web Management Interface does not allow variable length subnet
masks in the screens that add a DHCP Network Pool for a VLAN interface.
■ IDM (746917) — The IDM process was not available.
■ SFlow (746921) — The sFlow process was not available.
Release WS.02.14
Problems resolved In Release WS.02.14 (not a general release)
■ Wireless (45552) — Pairwise Master Key (PMK) caching allows the module to store a
station's PMK after the station disassociates with a Radio Port so that the key remains in
place if the station re-associates with a different Radio Port. Prior to this fix, network
administrators had to disable PMK caching to use the ACL features in IDM. This fix will
ensure that IDM ACLs will remain in place after a roam, with PMK caching enabled.
■ Wireless (45775) — ACL statistics were not being reported.