Wireless Edge Services xl Module Release Notes WS.02.27
Table Of Contents
- Release Notes: Version WS.02.27 Software for the ProCurve Wireless Edge Services xl Module (J9001A) and the ProCurve Redundant Wireless Services xl Module (J9003A)
- Copyright and Disclaimers
- Contents
- Software Management
- Support Notes
- Release WS.02.07
- Reconfigure Management Passwords After a Software Update from Version WS.01.xx to Version WS.02.xx
- Accessing the Web Browser Interface After a Software Update from Version WS.01.xx to Version WS.02.xx
- Configuring Authentication for Web-Users
- Special Characters for the ACL ID Field
- Correction: SNMP v3 Default Password
- Correction: Stations per Radio
- Correction: Stations per Module in a Layer 3 Mobility Domain
- Correction: Disabling TKIP Countermeasures
- Clarification: Setting Intrusion Detection with TKIP Countermeasures
- Release WS.02.07
- Enhancements
- Software Fixes
- Known Software Issues and Limitations
- Back Cover
3
Software Management
Saving Configurations
Saving the Current Configuration as the Start-Up Configuration
When you use the CLI to make a configuration change, the module places the change in the
running-config file. If you want to preserve the change across reboots, you must save the change to
the startup-config file. Otherwise, the next time the module reboots, the change will be lost.
To save configuration changes while using the CLI:
1. From the wireless-services context:
ProCurve Switch 5304XL(wireless-services-B)#write memory
[OK]
ProCurve Switch 5304XL(wireless-services-B)#
2. Verify that the [OK] message displays, indicating that the configuration was saved successfully.
The current configuration is now saved as the startup configuration file, and the module will
execute the file at each power-up.
See the Management and Configuration Guide (5013-5912) for more information on managing
module configuration files.