Wireless/Redundant Edge Services xl Module Management and Configuration Guide WS.02.xx and greater

2-23
Configuring the ProCurve Wireless Edge Services xl Module
Management Interfaces
From the enable context, you can enter show commands to view information
about the Wireless Edge Services xl Module, and you can perform some
operations such as erasing the startup-config file and copying configuration
files to and from the module.
To make configuration changes, however, you must move to the global con-
figuration context. From the global configuration context, you can enter
commands to change settings, or you can access other contexts that allow you
to change settings.
To move to the global configuration context for wireless services, enter:
ProCurve(wireless-services-C)# configure terminal
Again, the CLI prompt shows your new context:
ProCurve(wireless-services-C) (config)#
To view the commands available at any context, you can use a question mark:
ProCurve(wireless-services-C) (config)# ?
You can also use the question mark to view the options available for specific
commands:
ProCurve(wireless-services-C) (config)# ip ?
Saving Changes to the startup-config
When you make configuration changes to the Wireless Edge Services xl
Module, you must enter the write memory command to save these changes to
the module’s startup-config. When you enter this command, you must be in
the wireless-services context:
ProCurve(wireless-services-C)# write memory
If you exit the wireless-services context and enter the write memory command
in the CLI for the wireless services-enabled switch, the configuration changes
for the Wireless Edge Services xl Module are not saved to its startup-config file.
CLI Commands
See Appendix A, ProCurve Wireless Services xl Module Command Line
Reference for a list of CLI commands for the Wireless Edge Services xl Module
and their descriptions.