Wireless/Redundant Edge Services xl Module Management and Configuration Guide WS.02.xx and greater

2-89
Configuring the ProCurve Wireless Edge Services xl Module
System Maintenance
Figure 2-54. Management > System Maint.—Config Files > Transfer Screen
3. In the Source section, specify the source as an FTP or a TFTP server:
a. In the From field, use the drop-down menu to select Server.
b. In the File field, enter the name of the configuration file.
c. In the Using field, use the drop-down menu to select either FTP or TFTP.
d. In the Port field, if needed, change the port number for your FTP or
TFTP server. In most cases, the defaults (port 21 for FTP, port 69 for
TFTP) should apply to your server.
e. In the IP Address field, enter the IP address of the FTP or TFTP server.
f. If you are using an FTP server, enter the login credentials.
i. In the User ID field, enter the username for the FTP server.
ii. In the Password field, enter the password for this username.
g. In the Path field, enter the path where the configuration file is saved
on the server.
If you are using an FTP server and the configuration file is saved at
the server’s root level, enter a period followed by a slash (./). If the
configuration file resides at a different level on the FTP server, enter
the complete path. If you are using a TFTP server, this field may not
be required. However, enter the path if the file is stored in a subdirec-
tory on the TFTP server.