Wireless/Redundant Edge Services xl Module Management and Configuration Guide WS.02.xx and greater

2-97
Configuring the ProCurve Wireless Edge Services xl Module
System Maintenance
Note If you attempt to delete the startup-config file, the Web browser interface
allows you to go through the steps of deleting the file, but when you confirm
that you want to delete the file, the following message is displayed at the
bottom of the navigation bar:
You have selected the system startup-config file. This file cannot be edited.
Rather than trying to delete the startup-config file when you are using the Web
browser interface, you should return the file to factory default settings, as
explained in the next section. (You can enter the erase command in the CLI to
delete the startup-config. The module then uses the factory default startup-
config file.)
Returning the Startup-Config File to Factory Default Settings
Although you cannot delete the startup-config file if you are using the Web
browser interface, you can return this file to factory defaults. Complete
these steps:
1. On the Management > System Maint.—Config Files screen, click the Restore
Defaults button. A prompt is displayed, asking you to verify that you want
to return the startup-config file to factory defaults.
Figure 2-62. Restore Factory Defaults Prompt
2. Click the Yes button if you want to revert to factory settings. A prompt is
displayed, telling you that the Wireless Edge Services xl Module must be
rebooted in order for the change to take effect.
3. Click the Yes button to reboot the module.