Wireless/Redundant Edge Services xl Module Management and Configuration Guide WS.02.xx and greater

2-188
Configuring the ProCurve Wireless Edge Services xl Module
Digital Certificates
6. From the Using drop-down menu, select the protocol for the trustpoint
transfer, either FTP or TFTP.
7. In the Port field, enter the respective FTP or TFTP port number; the default
port number (port 21 for FTP, port 69 for TFTP) should apply in most
cases.
8. In the IP Address field, enter the IP address of the FTP or TFTP server.
9. If you are using an FTP server, enter the login credentials.
a. In the User ID field, enter the username for your account on the FTP
server.
b. In the Password field, enter the password for this username.
10. In the Path field, enter the path where the trustpoint will be stored on the
server. (If you are using a TFTP server, this field may not be required.)
11. Click the Transfer button. In the Status section at the bottom of the screen,
a message is displayed, reporting whether the transfer was successful.
12. After the trustpoint transfer is complete, click the Close button.
Transferring Trustpoints from a Server to the Wireless Edge
Services xl Module
To transfer a trustpoint from an external server to the Wireless Edge Services
xl Module, complete these steps:
1. Select Manager > Certificate Management and click the Trustpoints tab.
2. Click the Transfer Trustpoints button. The Transfer Trustpoints screen is
displayed.