Wireless/Redundant Edge Services xl Module Management and Configuration Guide WS.02.xx and greater

3-25
Radio Port Configuration
Configuring Radio Settings
Creating a Radio Configuration for a Particular Radio
When the Wireless Edge Services xl Module is powered on, it can identify and
adopt the RPs that are connected to the network. In “Creating a Radio
Adoption Default Configuration” on page 3-8, you learned how to configure
the settings that the module deploys to RPs when first adopted.
In this section, you will learn about configuring override settings for
particular identified radios. A radio’s
Configuration screen (accessed through
the
Network Setup > Radio > Configuration screen) allows you to modify radios’
settings and properties. (See Figure 3-10.) The Wireless Edge Services xl
Module associates these settings with the MAC address of the targeted radio
and always deploys this configuration to it, instead of the radio adoption
default configuration.
Most settings are established for particular radios in much the same way as
they are established in the radio adoption default configuration. (You simply
specify the setting on a particular radio’s Configuration screen instead of on a
radio type’s default Configuration screen.)
This section will explain how to alter settings for a particular radio; however,
it will focus on settings that are configured only for particular radios, not as
a part of a radio adoption default configuration. For more detailed information
on other settings, refer to sections in “Creating a Radio Adoption Default
Configuration” on page 3-8.