Wireless/Redundant Edge Services xl Module Management and Configuration Guide WS.02.xx and greater

3-36
Radio Port Configuration
Configuring Radio Settings
Configuring Multiple Radios at Once
To save time, you can configure settings for multiple radios at once. Hold down
<Ctrl> as you select the radios and click the Edit button.
The Configuration screen is displayed. You can edit the configuration much as
you would for a single radio. However, certain parameters are grayed out;
these parameters are restricted to configuration on one radio at a time. The
restricted promontories are:
■ channel setting
■ transmit power
■ short preamble requirement
If you have choose radios of both 802.11a and 802.11bg type, the restricted
parameters are:
■ placement
■ channel setting
■ transmit power
■ rate settings
■ short preamble requirement
For certain parameters, you can either edit the setting for all radios or allow
each radio to keep its current setting. These parameters are:
■ placement (for radios of the same type)
■ antenna mode
Other settings become identical for every selected radio after you click the
OK button.
Running ACS
If you have configured one or more radios to use ACS, you can have the
Wireless Edge Services xl Module reinitiate the ACS process. Rerunning ACS
after all RPs are adopted helps the radios to select the actual channel with the
least interference.
Complete these steps:
1. Select Network Setup > Radio > Configuration.