Wireless/Redundant Edge Services xl Module Management and Configuration Guide WS.02.xx and greater

3-40
Radio Port Configuration
Configuring Radio Settings
Managing RP Radios
You can perform several actions on an RP radio in the Network Setup > Radio
screen. Select the radio from the list and clicking the buttons at the bottom of
the screen:
■ Click the Edit button to alter a radio’s configuration. The Configuration
screen for that radio is displayed. (See “Configuring Radio Settings for a
Particular Radio” on page 3-30.)
■ Click the Delete button to delete a radio configuration and unadopt the
radio. The radio will immediately be readopted unless you have taken
steps to prevent it being so (for example, clicking the Global Settings
button and disabling manual adoption). However, the radio receives the
radio adoption default configuration, which writes over any configuration
previously created for it.
Clicking the Delete button also erases the configuration of an RP radio
that was once adopted by this module, but is so no longer.
■ Click the Add button to adopt a RP when automatic adoption is disabled.
(See “Radio Port Adoption” on page 2-56 of Chapter 2: Configuring the
ProCurve Wireless Edge Services xl Module.)
You also use the Add button to create a pre-adoption configuration tar-
geted for a particular radio.
When you click the Add button, the Add Radio screen is displayed.
Figure 3-19. Add Radio Screen