HP Smart Update Manager 5.0 User Guide

HP SUM User Interface 28
3.
Check each component that you want to update on the selected target. If there is a dependency failure,
click Failed Dependency to see potential solutions for the failed dependency.
NOTE: If you select individual components from the Select Unbundled Components list on the
Select Bundles screen, these selections are also applied to the Select Components screen.
NOTE: If HP SUM shows no devices you can update, you might need to change the types of
updates to use on the Edit Repository screen. For more information, see "Edit Repository (on page
20)."
Select components
This screen allows you to install individual smart components that are not contained in a bundle. You can
choose the devices to update, and choose whether to activate the updates immediately, or wait until the next
scheduled target maintenance.
1. In the Review/Install window, click Select Components for a target. The Select Components screen
shows applicable components.
2. Select the components that you want to install.
3. Click Configure Now and then select Upload and Active to activate the update. To wait until the next
scheduled maintenance to activate the update, select Upload and Do not Activate.
4. Check each component that you want to update on the selected target. If there is a dependency failure,
click Failed Dependency to see potential solutions to the failed dependency.
NOTE: If HP SUM shows no devices you can update, you might need to change the types of
updates to use on the Edit Repository screen. For more information, see "Edit Repository (on page
20)."
5. Click OK.
View firmware mismatch details
If you have a multi-blade server, you might encounter an instance where the device bays are running different
versions of component firmware. Before you can update the server, you need to first correct the mismatch.
Use HP SUM to update the bays so that they are using the same firmware version. After you update the bay
firmware, close HP SUM. To perform the remaining updates, reopen HP SUM.
Select devices
On the Select Devices screen, select the devices on the target that you want to update. You can also review
any dependency problems that need to be resolved before HP SUM begins the update installation.
To select devices:
1. To reach the Select Devices screen, click Select Devices on the Select Bundles or Select Components
screen.
2. Select the checkbox for the device that you want to update. The Status field displays messages about the
selected device. If you cannot update a device, the Status field displays a brief explanation.
3. View any errors or warnings displayed at the bottom of the screen. Correct errors before continuing.
Warnings do not prevent the installation, but continuing an installation without correcting the problem