HP Smart Update Manager 5.0 User Guide

Introduction 9
o
e2fsprogs-32bit
• For SLES 11 x86 servers:
o libstdc++33-3.3.3-11.9.i586 or later
o libnl (required for QLogic and Emulex drivers)
• For SLES 11 AMD64/EM64T servers:
o libstdc++33-32bit-3.3.3-11.9 or later
o libnl (required for QLogic and Emulex drivers)
Minimum requirements for Red Hat Enterprise Linux 6 servers
NOTE: The following versions listed are needed as a minimum. Later versions of these might be
used as well.
NOTE: Ensure that each NIC has an IP address assigned. To get the IP address assigned to a
NIC, enter the dhclient command in the console, which enables the NIC interfaces and
retrieves an IP address. If a NIC does not have an IP address, HP SUM appears to hang on start
up.
• RHEL6 console mode
NOTE: No X console in either x86 or x86_64 servers. To run HP SUM in silent mode, you must
install the base server with defaults and the following RPMs.
o lm_sensors-libs-3.1.1-10.el6.<arch>.rpm
o net-snmp-libs-5.5-27.el6.<arch>.rpm
o net-snmp-5.5.27.el6.<arch>.rpm
o kernel-headers-2.6.32-71.el6.<arch>.rpm
o redhat-rpm-config-9.0.3-25.el6.noarch.rpm
o kernel-devel-2.6.32-71.el6.<arch>.rpm
o rpm-build-4.8.0-12.el6.<arch>.rpm
o gcc-4.4.4-13.el6.<arch>.rpm
• RHEL6 graphical mode
NOTE: If the user elects to install the XWindows support, then the following steps apply to both
x86 and x86_64 servers.
NOTE: The following items must be the 32-bit version even under x86_64 architecture as HP
SUM and several of the RPMs require 32-bit libraries installed.
o libuuid-2.17.2-6.el6.i686.rpm
o freetype-2.3.11-5.el6.i686.rpm
o libSM-1.1.0-7.1.el6.i686.rpm
o libICE-1.0.6-1.el6.i686.rpm
o libXi-1.3-3.el6.i686.rpm
o libX11-1.3-2.el6.i686.rpm
o libXext-1.1-3.el6.i686.rpm