HP Remote Graphics Software 5.4.0 User Guide

requests on network interface 1 (corresponding to Local Area Connection 4), even though network
interface 1 is the second network interface in binding order.
Figure 4-6 Network Interface binding order numerical sequence
Again, refer to Network Interface binding properties on page 179 for a description of these
properties.
4.4 Using RGS through a firewall
New at RGS 5.1.5 is the ability for the Receiver to use the public IP address of the Sender. This feature
has been added to allow RGS to be used through a firewall. To take advantage of this feature, the
Sender and Receiver firewalls must both support NAT (Network Address Translation). In addition, the
Sender firewall must support port forwarding (see
Figure 4-7 RGS operation through a firewall
on page 84).
Figure 4-7 RGS operation through a firewall
84 Chapter 4 Pre-connection checklist ENWW