HP Remote Graphics Software 5.4.0 User Guide

NOTE: The port used by the RGS Receiver is assigned by the Local Computer OS and can vary. The

RGS Sender listens on TCP/IP port 42966. At RGS 5.2.5, the capability was added to specify the port

number used by the RGS Sender. The default Sender port number is 42966, as noted above. The

Sender port number can be changed using the Rgsender.Network.Port property as described in

Network Interface binding properties on page 179. If this property is used to change the Sender port

number from its default value of 42966, the Sender port number must then be specified in establishing

an RGS connection from the Receiver to the Sender.

ENWW

Using RGS through a firewall