HP Remote Graphics Software 5.4.0 User Guide

Figure 6-4 Microphone device selection and audio playback device selection on the Sender
NOTE: Remote Microphone can be enabled/disabled using the Rgsender.Mic.IsEnabled property, as
described in the section
Microphone property group on page 178.
The HP Remote Audio device has only the mixer available in the recording control panel and the
volume level for this line cannot be adjusted. If an audio device is detected during installation, an
attempt is made to select the mixer as the recorder input. Due to wide variations in naming and volume
levels, it is likely that the mixer line will need to be selected by hand.
106 Chapter 6 Advanced capabilities ENWW