HP Remote Graphics Software 5.4.0 User Guide

Introduced at RGS 5.2.0, this property allows the user to enable or disable display of the collaboration
notification dialog (see
Collaboration notification dialog on page 100 ). If set to 1, the collaboration
notification dialog is displayed. If set to 0, the collaboration notification dialog is not displayed. The
default value is 1—display the collaboration notification dialog.
CAUTION: Caution is advised in disabling the collaboration notification dialog because neither the
Remote User (if present) or the Local Users will be notified who is participating in a collaboration
session. Furthermore, if display of the collaboration notification dialog is disabled, the warning dialog
in
Figure 5-7 Local Computer warning dialog if the Remote Computer is unable to blank its monitor
on page 93 (which is displayed when the Remote Computer is unable to blank its monitor) will also be
prevented from being displayed.
Rgsender.IsReconnectOnConsoleDisconnectEnabled=bool （1）
Introduced at RGS 5.3.0, this property allows the user to enable or disable session reconnection during
session logout or Fast User Switching. Supported on Windows Vista and later. The default value is 1.
See
Sender and Receiver interoperability on page 14 for more details.
8.6.3 Microphone property group
Rgsender.Mic.IsEnabled=bool （1）
This property is new with RGS 5.1.3, and is only supported on the Windows Sender. If set to 1, remote
microphone is enabled (on/unmuted). If set to 0, remote microphone is disabled (off/muted). The
default value is 1—remote microphone is enabled (on/unmuted).
8.6.4 Sender network timeout properties
Rgsender.Network.Timeout.Error=int （30000）
The timeout in milliseconds used to detect and disconnect an inactive connection. The default value is
30,000 milliseconds (30 seconds). See
Adjusting Network timeout settings on page 127 for more
details.
Rgsender.Network.Timeout.Dialog=int （15000）
The timeout in milliseconds used to display and wait on responses from input dialogs, such as the
authorization dialog and PAM authentication dialog. The default value is 15,000 milliseconds (15
seconds). See
Adjusting Network timeout settings on page 127 for more details.
8.6.5 Sender USB access control list properties
The following properties provide information on the access control list (ACL) file used to control the
attachment of USB devices to a Remote Computer. See
Remote USB Access Control List on page 119
for information on the ACL file.
Rgsender.Usb.Acl.RulesetPath=string （hprDefaultUsbAcl.xml）
This property specifies the name of the XML file that implements the remote USB Access Control List
(ACL).
Rgsender.Usb.Acl.SchemaPath=string （hprUsbAcl.xsd）
This property specifies the name of the schema file that accompanies the remote USB XML file.
Rgsender.Usb.Acl.RulesetErrorTimeout=int （5000）
178 Chapter 8 RGS properties ENWW