HP Remote Graphics Software 5.4.0 User Guide

Connection denied! The iLO remote console is enabled. The iLO remote console is enabled on the HP Blade
Workstation. The Blade must be configured in User Mode
before connections are allowed.
Unable to connect to Sender: The Receiver was unable to
resolve the specified hostname or IP Address. Verify that you
entered the value correctly.
This is usually indicative of a DNS error.
Unable to connect to Sender: The Receiver resolved the
specified hostname or IP address, but cannot connect to the
Sender. Verify that the system is accessible on your network
and that the Remote Graphics Sender service has been started
and is listening on a pubic IP address and is not blocked by a
firewall.
The Receiver was able to look up and resolve the specified
hostname or IP address. However, the Receiver was unable to
establish a connection to the Sender. There are several
possibilities such as the Sender is not installed, the Sender is
not running, the Sender is listening on the wrong network
interface, or a firewall is blocking the Sender.
208 Chapter 13 RGS error messages ENWW