Manualshelf

HP StorageWorks SAN Virtualization Services Platform 2.1 release notes (5697-8060, March 2009)

ManualsBrandsHP ManualsSoftwareHP SAN Virtualization Services Platform Business Copy SW 1TB 101-250TB E-LTU
11121314151617181920
The ResumeLocalAsyncMirrorTask command does not work in HP-UX the first time
The ResumeLocalAsyncMirrorTask command may not work until the second time it is executed
in HP-UX. Therefore, either try rerunning the command, or run the
ResumeAllLocalAsyncMirrorTasks command instead. HP is working to resolve this issue.
The ResumeLocalAsyncMirrorTask command gives error in HP-UX if already resumed
If a task has already been resumed in HP-UX, and the ResumeLocalAsyncMirrorTask command
is executed, you will receive an error message. The correct response should be the message There
is nothing to resume. HP is working to resolve this issue.
Incorrect error message when ManageSnapcloneGroup command is missing the Opcode
argument in HP-UX
If the Opcode argument is missing from the ManageSnapcloneGroup command in HP-UX, you will
receive an incorrect error message stating that both parameters are missing, instead of only the
Opcode missing. HP is working to resolve this issue.
The CreateSnapcloneGroupEx command fails with HP-UX if the group is still building
The CreateSnapcloneGroupEx command should run the first time. However, with HP-UX, if the
command is run again while the snapclone operation is still building the copy, the command fails.
You should increase the timeout argument to as long as you believe the building operation should
last. HP is working to resolve this issue.
The CreateSnapshotWithLun command fails to get last PiT instance for Pit26 with HP-UX
In HP-UX, use the SetUDHVirtualDiskLun command to change the snapshot LUN number. HP is
working to resolve this issue.
Do not use DeleteVirtualDisk command with LastInstance argument in HP-UX
In HP-UX, the use of the LastInstance argument with the DeleteVirtualDisk command is not
supported at this time. HP is working to resolve this issue.
Error with DeleteVirtualDisk command when virtual disk LUN number is out of range
When deleting a virtual disk with the DeleteVirtualDisk command, and the LUN number is out
of range, you will receive a SCSI I/O error message. This is expected behavior.
The CreateAsyncMirrorGroupEx command cannot be run in Linux
At this time, the CreateAsyncMirrorGroupEx command cannot be run in Linux. HP is working to
resolve this issue.
18