HP StorageWorks SAN Virtualization Services Platform administrator guide (5697-0109, July 2009)

Viewing licensed capacity
From within the VSM client, in the menu bar, click Tools > License. The License dialog box appears.
Figure 5 License dialog box
The following table describes the capacities listed in the License dialog box. Each capacity features
its total amount, the amount used, and the amount available.
Table 3 License capacities
DescriptionProperty
The amount of licensed capacity allotted for basic operations (for example, the
maximum size of all pools). See Table 2 on page 21).
Basic capacity
The amount of licensed capacity allotted for local replication (for example, the
size of all parents). If your license does not allow Business Copy operations, this
amount is zero (see Table 2 on page 21).
BC capacity
The amount of licensed capacity allotted for remote replication. If your license
does not allow Continuous Access operations, this amount is zero (see Table
2 on page 21).
CA capacity
The amount of licensed capacity allotted for thin provisioning. If your license does
not allow thin provisioning operations, this amount is zero (see Table
2 on page 21).
TP capacity
The number of DPM ports, four at a time, issued for a DPM group. There are a
total of 16 ports per DPM. One dual 4–port LTU turns on 8 ports (4 per DPM).
DPM ports number
Zoning
See “Zoning” on page 49 for a detailed description of how to incorporate zoning into your domain.
Adding a new array
The following guidelines must be observed when adding arrays to the domain:
• An array must be attached to both fabrics.
• Back-end zones are created as described in “Zoning” on page 49. Two sets are needed and are
defined as follows:
• Array to DPMs
HP StorageWorks SAN Virtualization Services Platform administrator guide 23