HP StorageWorks Virtualization Services Manager v2 server user guide (5697-0137, September 2009)

Front panel LEDs and buttons

Table 2 Front panel LEDs and buttons

StatusDescriptionItem

Blue = Identification is activated.

Flashing blue = System is being managed remotely.

Off = Identification is deactivated.

UID LED/button1

Green = System health is normal.

Amber = System health is degraded. To identify the component in a

degraded state, see “HP Systems Insight Display LEDs” on page 11.

Red = System health is critical. To identify the component in a critical

state, see “HP Systems Insight Display LEDs” on page 11.

Off = System health is normal (when in standby mode)

Health LED2

Green = Network link exists.

Flashing green = Network link and activity exist.

Off = No link to network exists.

If power is off, the front panel LED is not active. For status, view the

RJ-45 connector LEDs (“Rear panel LEDs and buttons” on page 10).

NIC 1 link/activity LED3

Green = Network link exists.

Flashing green = Network link and activity exist.

Off = No link to network exists.

If power is off, the front panel LED is not active. For status, view the

RJ-45 connector LEDs (“Rear panel LEDs and buttons” on page 10).

NIC 2 link/activity LED4

Green = System is on.

Amber = System is in standby, but power is still applied.

Off = Power cord is not attached, power supply failure has occurred,

no power supplies are installed, facility power is not available, or the

power button cable is disconnected.

Power On/Standby but-

ton and system power

LED

Component identification8