HP StorageWorks SAN Virtualization Services Platform administrator guide (5697-8056, March 2009)

4. Make sure you are using the correct HBA driver.
VMware multipathing
For VMware, the multipathing policy must be set to the Most Recently Used (MRU) path.
Windows multipathing
1. Go to http://h18006.www1.hp.com/products/sanworks/softwaredrivers/multipathoptions/
windows.html.
2. Under Select your product, click Windows MPIO DSM for SVSP. This product contains an
active-passive multipath driver.
3. Select your operating system.
4. Select your software/driver language.
5. Select HP MPIO Full Featured DSM, and then click Download for that product version.
6. Read and print the readme file included with the downloaded driver. The file contains installation
instructions and any limitations.
7. Disconnect the server from the SAN.
8. Install the multipathing drivers.
After the drivers are installed, you must enable persistent binding to maintain consistent driver letters.
Described below are procedures for QLogic and Emulex HBAs.
QLogic HBAs with Windows
To enable persistent binding with QLogic HBAs:
1. Launch Sansurfer. This application can be downloaded from hp.com or qlogic.com.
2. Connect to Localhost. The utility displays all QLogic HBAs recognized in the system.
3. Select the port on the HBA to be enabled for persistent binding.
4. Select the Target Persistent Binding tab.
HP StorageWorks SAN Virtualization Services Platform administrator guide 29