HP StorageWorks SAN Virtualization Services Platform Data Path Module User Guide (5697-0772, November 2010)
IPv4, IPv6
address [IP address]
IP address of the interface.
gateway [gateway address]
IP address of the network gateway.
netmask [subnet mask]
Mask bits for subnet routing.
Notes
If you are connected through the management port, modifying the MGMT Ethernet terminates any
active network GUI and CLI sessions, requiring a re-login through the serial or MGMT port. If you are
using the CLI on the serial console, the connection is not disrupted.
See also
“Disable eth command” on page 22
“Enable eth command” on page 27
“Set eth command” on page 47
“Show eth command” on page 54
“Show eths command” on page 55
Modify factory command
Restore the factory rank or the factory WWNN value.
Syntax
modify factory rank [rank-value]
modify factory wwnn [wwnn-value]
Keyword values
At least one of the optional keywords is required:
[rank-value]
New rank value (Primary or Secondary).
[wwnn-value]
New WWNN to set.
See also
“Load factory command” on page 35
“Show factory command” on page 55
HP StorageWorks SAN Virtualization Services Platform Data Path Module User Guide 37