HP StorageWorks SAN Virtualization Services Platform Data Path Module User Guide (5697-0772, November 2010)
reset debug level [module]
Keyword values
[module]
Kernel module that will specifically have its debug level reset. If no value is specified (reset debug),
then all debug levels for all modules are reset.
See also
“Create debug command” on page 18
“Load debug command” on page 34
“Save debug command” on page 46
“Set debug command” on page 46
“Show debug command” on page 51
Reset port command
Shuts down the port and then restarts it, leaving the properties of the port unchanged. Use this command
to clear a port that is in an unknown state and trigger the discovery process.
CAUTION:
Running this command disrupts any traffic on this port, and should never be performed on a port that
is moving data. Doing so could cause read/write failure and error conditions in software if traffic
has occurred.
Syntax
reset port
[port number]
*
Keyword values
[port number]
Port number is an integer 0–15 for the DPM to indicate the Fibre Channel port.
* indicates all Fibre Channel ports.
See also
“Modify ports command” on page 39
“Show port command” on page 59
“Show ports command” on page 60
CLI commands44