HP StorageWorks SAN Virtualization Services Platform Data Path Module user guide (5697-8058, March 2009)
“Enable port command” on page 33
“Modify port command” on page 42
“Modify ports command” on page 43
“Reset port command” on page 48
“Show ports command” on page 64
Show ports command
Returns diagnostic and status information for all ports on the DPM. See the sample output in the
Examples section below for more information.
Syntax
show ports
Keywords
ports
Indicates all Fibre Channel ports on the DPM.
Examples
Here is a sample output after running show ports.
Num State Cap. Type(conf/act) Speed Mtu
0 ESTABLISHED TARG FABRIC/FABRIC NEG/4G 2048
1 ESTABLISHED INIT FABRIC/FABRIC NEG/4G 2048
2 ESTABLISHED TARG FABRIC/FABRIC NEG/4G 2048
3 ESTABLISHED INIT FABRIC/FABRIC NEG/4G 2048
4 NO-SIGNAL TARG FABRIC/UNSET NEG/UND 2048
5 NO-SIGNAL INIT FABRIC/UNSET NEG/UND 2048
6 NO-SIGNAL TARG FABRIC/UNSET NEG/UND 2048
7 NO-SIGNAL INIT FABRIC/UNSET NEG/UND 2048
8 NO-SIGNAL TARG FABRIC/UNSET NEG/UND 2048
9 NO-SIGNAL INIT FABRIC/UNSET NEG/UND 2048
10 NO-SIGNAL TARG FABRIC/UNSET NEG/UND 2048
11 NO-SIGNAL INIT FABRIC/UNSET NEG/UND 2048
12 NO-SIGNAL TARG FABRIC/UNSET NEG/UND 2048
13 NO-SIGNAL INIT FABRIC/UNSET NEG/UND 2048
14 NO-SIGNAL TARG FABRIC/UNSET NEG/UND 2048
15 NO-SIGNAL INIT FABRIC/UNSET NEG/UND 2048
See also
“Disable port command” on page 28
“Enable port command” on page 33
“Modify port command” on page 42
“Modify ports command” on page 43
“Reset port command” on page 48
“Show port command” on page 63
CLI commands64