HP StorageWorks SAN Virtualization Services Platform Manager Command Line Interface User Guide (5697-0936, May 2011)

NOTE: This command tries to process all qualified tasks, ignoring failures in some tasks (if any).
ResumeLocalAsyncMirrorGroup command
Syntax
ResumeLocalAsyncMirrorGroup -Group AsyncMirrorGroupName_1 ~
[-Group AsyncMirrorGroupName_2, . . . , ] ~
-timeout 900
Description
Resumes the local asynchronous mirror groups previously paused. Local means the source virtual
disk is in the local (current) SVSP domain.
NOTE: If a failure occurs for any group on the list, the command stops executing and does not
process the remaining list.
ResumeLocalAsyncMirrorTask command
Syntax
ResumeLocalAsyncMirrorTask -Group AsyncMirrorGroupName, ~
-task AsyncMirrorTaskName_1, ~
[-task AsyncMirrorTaskName_2, . . . , ] ~
-timeout 900
Description
Resumes the tasks of a local asynchronous mirror group that were previously paused. Local means
the source virtual disk is in the local (current) SVSP domain.
NOTE:
• If a failure occurs for any task on the list, the command stops executing and does not process
the remaining list.
• When run under HP-UX, and the task has already been resumed, you will receive an error
message that you should ignore.
Synchronous mirror commands
AddSyncMirrorTaskToGroup command
Syntax
AddSyncMirrorTaskToGroup -Group SyncMirrorGroupName, ~
-Domain DestinationVSMDomainName, ~
-VirtualDisk DestinationVirtualDisk, ~
-StoragePool DestPoolName,
[-WaitForSync 0|1 ,] -timeout 900
Description
Adds a synchronous mirror task to the synchronous mirror group.
By default, the CLI returns after the task status is normal, which means that the synchronized
operation was completed (WaitForSync=1). For the CLI to return immediately after task creation,
the WaitForSync argument should be reset (WaitForSync=0).
50 Using the VSM command line interface