HP StorageWorks SAN Virtualization Services Platform 3.0.2 Release Notes (5697-0347, May 2010)

Incorrect error message when creating 65th PiT on a virtual disk

When creating the 65th PiT on a virtual disk using the VSM CLI, you receive an error message

indicating A SCSI error in I/O to the switch. The correct error message should be the

Virtual disk has too many PiTs. HP is working to resolve this issue.

The ListSnapshots command fails to return data with too many PiTs

The ListSnapshots command with a –PiT argument does not return data with 2048 PiTs. The

ListVirtualDisks and ListSnapshots command are restricted to less than 1500 items. HP is

working to resolve this issue.

The DeleteRemoteAsyncMirrorGroup command does not work in HP-UX

In HP-UX, use the DeleteLocalAsyncMirrorGroup command in place of

DeleteRemoteAsyncMirrorGroup. HP is working to resolve this issue.

The BreakAllRemoteAsyncMirrorTasks command does not work in HP-UX

The BreakAllRemoteAsyncMirrorTasks command does not work in HP-UX and returns the

message Pass O.K. HP is working to resolve this issue.

The ? wildcard character in HP-UX is not reliable

The ? wildcard character can display VSM CLI commands that are not supported for a given command

mask. HP is working to resolve this issue.

The ResumeLocalAsyncMirrorTask command does not work in HP-UX the first time

The ResumeLocalAsyncMirrorTask command may not work until the second time it is executed

in HP-UX. Therefore, either try rerunning the command, or run the

ResumeAllLocalAsyncMirrorTasks command instead. HP is working to resolve this issue.

The ResumeLocalAsyncMirrorTask command gives error in HP-UX if already resumed

If a task has already been resumed in HP-UX, and the ResumeLocalAsyncMirrorTask command

is executed, you will receive an error message. The correct response should be the message There

is nothing to resume. HP is working to resolve this issue.

Incorrect error message when ManageSnapcloneGroup command is missing the Opcode

argument in HP-UX

If the Opcode argument is missing from the ManageSnapcloneGroup command in HP-UX, you will

receive an incorrect error message stating that both parameters are missing, instead of only the

Opcode missing. HP is working to resolve this issue.