HP Smart Update Manager 5.3 User Guide

Viewing firmware details
You can view the firmware detail screen from these screens:
• Review/Install Updates
• Select Bundles
• Select Components
To open the view firmware details, do one of the following:
• Click Installed Version on the Select Bundles or Select Components screen.
• HP Integrity servers only: Click Mismatch Found on the Review/Install Updates screen, if
displayed.
The View Firmware Details screen provides information about:
Table 1 View Firmware Details screen
HP Integrity serversHP ProLiant servers
Bundle versionSPP version
iLO version (NIC version on HP–UX servers)NIC version
Power Monitor firmware versionFirmware version
System firmware versionComponent versions
FPGA firmware versionBundle version
• Bundle version
NOTE: The bundle version is only displayed if all four firmware versions match a known
bundle. If there is no known bundle, then HP SUM will display Unknown.
• iLO firmware version
• Power Monitor firmware version
• System firmware version
• FPGA firmware version
Viewing firmware mismatch details (HP Integrity servers only)
If you have a multi-blade server, you might encounter a situation where you have blades or partitions
that are running different firmware versions. As part of the update procedures, HP SUM will notify
you that there is a firmware mismatch by displaying either Mismatch Found or Mismatch
Found Update Required. Click the message to go to the View Firmware Details screen, where
you can view the mismatch details. HP SUM will resolve the firmware mismatch when it installs the
new updates.
Installation options
CAUTION: The ability to force the installation of components is generally unnecessary and is not
recommended. Incorrect use could result in data loss or system failure or both.
If you set the installation options from the Review/Install Updates screen, you set these options for
all the targets. If you want to set installation options for specific targets, click Select Bundles or
Select Components for the target, and then click Installation Options for the target.
1. Click Installation Options.
2. Click Check here to enable force options.
28 Using the HP SUM GUI