HP Smart Update Manager 5.3 User Guide

Input file parameters
Possible valuesDescriptionParameter
YES, NOThis parameter causes the installation
to run silently without GUI or console
SILENT
output. All data is written to the log
file. Any generated prompts use the
default option and continue the
installation without user input.
If a component requires input before
installation (such as configuration
information), the component
installation fails (unless the
IGNOREERRORS =
"FailedDependencies" parameter is
supplied), and an error message is
written to the log file.
/targettype vcThis parameter specifies the target
type and can shorten the discovery
process.
TARGETTYPE
If you use the command with a
group, the HP SUM assumes all
targets in the group are the same
target type.
YES, NOForces updates to both firmware and
software components.
FORCEALL
YES, NOForces updates to firmware
components.
FORCEROM
YES, NOForces updates to software
components.
FORCESOFTWARE
YES, NOEnables you to override or downgrade
an existing installation of components
in the selected bundle.
FORCEBUNDLE
YES, NODowngrade to an earlier version of
firmware for multi-target devices such
DOWNGRADE
as hard drives and array controllers.
(Applies to firmware only.)
YES, NORewrite the same version of firmware
only for multi-target devices such as
REWRITE
hard drives and array controllers.
(Applies to firmware only.)
YES, NOEnables you to reboot, if required.REBOOTALLOWED
Any string (not exceeding 256
characters)
Create a message to be displayed
prior to rebooting.
REBOOTMESSAGE
Time in secondsDelay before rebooting.REBOOTDELAY
Component names with file
extensions (.exe, .rpm, or .scexe)
Limit the list of components to be
updated.
COMPONENTSLIST
Bundle file namesLimit the list of bundle xml files to be
filtered.
BUNDLESLIST
YES, NOThis is a filter switch and enables you
to install newer versions of
ALLOWUPDATEBUNDLE
components defined in a PSP, ISP, or
bundle.
This parameter enables these
components to replace the older
Input files 45