HP Smart Update Manager 6.0.1 Release Notes (Ed. 3)

1. When performing online updates with HP SUM on a fresh installation of a supported Windows
or Linux OS, all of the appropriate drivers are listed on the Review/Deploy screen but all of the
applicable firmware components might not be listed.
2. Network Adapters (NICs), Host Bus Adapters (HBAs), and iLO require a driver or enablement kit
to be installed in order to be recognized by HP SUM.
3. When running HP SUM on Windows, if the iLO Channel Interface Driver is not installed, the iLO
FW will show a version of 'None' as the installed version and 'Ready for Installation' as the status
on the Select Bundle or Select Component page. This applies to firmware for iLO 2, 3, and 4.
When you try to update the firmware, it might not update if it is already up to date.
4. Broadcom NICs are not discovered by HP SUM unless the appropriate driver is installed and all
Ethernet ports are up. You can bring up the Ethernet port by using the following command:
# ifup ethx
or
# ifup ethx up
To update the firmware for Broadcom NIC, use the following steps:
• Install the appropriate Windows or Linux driver found in the SPP. If updating a Linux server,
the driver can also be retrieved from the SDR or the Linux distro.
• Enable all the Ethernet ports
• Run the Broadcom FW upgrade component
When updating Windows Server 2012 systems using HP SUM, HP Storage Brocade Storport Fibre
Channel Host Bus Adapter Driver for Microsoft Windows Server 2012 R2 and HP Firmware Online
Flash for Brocade Fibre Channel Host Bus Adapters - Windows Server 2012 R2 (x64), might incorrectly
appear as available for update
When updating Windows Server 2012 (non-R2) systems using HP SUM, the following components
might incorrectly appear as available for deployment and two driver components and two firmware
components might be shown in the HP SUM GUI as available for deployment on Windows 2012
target nodes. Those components are the HP Storage Brocade Storport Fibre Channel Host Bus Adapter
Driver for Microsoft Windows Server 2012 R2 and the HP Firmware Online Flash for Brocade Fibre
Channel Host Bus Adapters - Windows Server 2012 R2 (x64). For Microsoft Windows Server 2012
(non-R2) target nodes, select: Driver 3.2.1.0, cp019320 Firmware 2013.08.01, cp019374 Deselect:
Driver 3.2.3.1, cp021773 Firmware 2013.11.01, cp022023.
HP SUM session issues
HP SUM does not display the download from hp.com button
This version of HP SUM does not support downloading updates from hp.com to add a baseline to the
baseline library. HP SUM will include this function in a future version.
Suggested Action: Download the updates, place them in a directory, and then add the directory as a
baseline in HP SUM.
HP SUM displays a certificate warning when connecting to HP SUM from a remote browser.
HP SUM versions 6.0.1, 6.2.0, and 6.3.0 contain a certificate that expires in 2016.
Suggested Action: You can ignore the warning, but HP recommends updating to HP SUM 6.3.1 or
later if you encounter this warning. HP SUM includes a newer certificate that does not display this
warning.
HP SUM does not start on ports lower than 1024 if you use the /port or /ssl_port parameters
Suggested Action: Use the following instructions to work around the issue:
Issues and suggested actions 17