Designing Disaster Tolerant High Availability Clusters, 10th Edition, March 2003 (B7660-90013)

Building a Continental Cluster
Switching to the Recovery Packages in Case of Disaster
Chapter 5252
Halting data receiver package nfsreceiverpkg on recovery
cluster eastcoast
Starting recovery package nfsbackuppkg on recovery cluster
eastcoast
enabling package nfsbackuppkg in cluster eastcoast
-----------------
exit status = 0
-----------------
The command cmrecovercl starts up all the recovery packages that are
configured in the recovery groups. In addition to starting the recovery
packages all at once, you may also recover an individual recovery group
by using the following commands:
# cmrecovercl -g Recovery_Group_Name
Running the cmrecovercl with option “-g” starts up only the recovery
package configured in the specified recovery group.
NOTE After the cmrecovercl command is issued, there is a delay of at least 90
seconds per recovery group as the command makes sure that the package
is not active on another cluster. Please be patient.
Use the cmviewcl command on the local cluster to confirm that the
recovery packages are running correctly. Following recovery, you can
halt the package that was monitoring the remote cluster if you wish. If
you do not do so, you will continue to receive notification if there is a