Serviceguard Extension for RAC Version A.11.19 Release Notes (May 2010)

Installing Serviceguard Extension for RAC
To install Serviceguard Extension for RAC independently, follow these steps:
1. Install or upgrade to HP-UX 11i v2 or 11i v3 before loading Serviceguard Extension for RAC
Version A.11.19.
2. Use the swinstall command to install SGeRAC, product number T1907BA.
3. Verify the installation. Use the following command to display a list of all installed components:
# swlist -R T1907BA
Serviceguard version A.11.19 will automatically be installed as part of the bundle installation
process.
The correct version of SGeRAC will automatically be installed when you install one of the HP
Serviceguard Storage Management Suite bundles. If SG SMS is already installed, do not install
SGeRAC independently.
For more information, see the HP Serviceguard Storage Management Suite Release Notes for your
version at http://www.hp.com/go/hpux-serviceguard-docs —> HP Serviceguard
Storage Management Suite.
After installation, you can use commands such as the following to display a list of all installed
components:
swlist -R T1905CA
swlist -R T1907BA
NOTE:
If you are adding Serviceguard Extension for RAC to an existing Serviceguard cluster, there are
additional steps. See “Adding Serviceguard Extension for RAC to an Existing Cluster” on page 15.
For more information, see:
• Managing HP-UX Software with SD-UX
• the swinstall (1M) manpage
Adding Serviceguard Extension for RAC to an Existing Cluster
If you have already installed Serviceguard and are running a Serviceguard cluster, use the following
steps to add SGeRAC:
NOTE:
An SGeRAC cluster must have the same version of Serviceguard and SGeRAC software installed on
all nodes.
1. Halt the cluster.
2. Use swinstall to install SGeRAC on each node.
3. Modify the cluster configuration file as necessary for RAC use, add OPS_VOLUME_GROUP if re-
quired, and then run cmapplyconf.
4. Reboot each node.
Serviceguard Extension for RAC Version A.11.19 Release Notes 15