HP Serviceguard for Linux Version A.11.19 Deployment Guide, September 2012

4. At the prompt, enter the “set network-parameters” command to configure the IP address for

the controller connected to the network. For example, type the following command (as a

single command):

NOTE: It is assumed that one of the controllers is already connected to a network switch

using an Ethernet cable. In this example, the Ethernet cable is plugged into controller A.

5. To verify the setting, enter the following command:

6. Disconnect from the CLI and exit the emulator.

To verify, ping the address from another device on the network.

If there are problems after 3 minutes, type the following command at the CLI of the MSA2000 to

restart the management controller on both controllers:

Creating a User Login from the CLI

By default, a user and password of manage/manage should already exist on the storage server to

provide access to the browser-based Storage Management Utility (SMU).

If you want to change the defaults or add additional users, this can be done using the CLI through a

terminal emulator. Follow the instructions above to establish a Hyperterminal connection to the

controller. Here is an example of a command to create a new user, jsmith, with “manage” (modify)

capabilities, and access to the command line interface and the web-browser interface. You will be

prompted to input the password:

create user jsmith level manage interfaces cli, wbi

Enter Password for new user jsmith:*****

Re-enter Password:*****

Info: User Type not specified, defaulting to Advanced.

Success: New user created

To change the default manage password, use the following command:

set password manage

Enter new password:****

Verify new password:****

Info: Changing password for user: manage

Success: Password set

Configuring the MSA2000

This section provides instructions for the initial configuration of the storage device, configuration

settings for the connected hosts, and the creation of a virtual disk and its volumes.

1. Go to SMU from a browser with access to the network, for example:

http://16.89.84.235

NOTE: If the menu options in the left hand column do not appear, try the “Refresh” option in

the browser.