Managing HP Serviceguard Extension for SAP for Linux, December 2013

There are two tables in this screen, Select Nodes and Specify Parameters. By default, nodes
and node order are pre-selected in the Select Nodes table. You can clear the selection or
change the node order, to accommodate your configuration requirements. Alternatively, you
can select Enable package to run on any node configured in the cluster (node order defined
by Serviceguard) and allow Serviceguard to define the node order.
To help in decision making, you can move the cursor over the configurable parameters, and
view the tool tips that provide more information about the parameter.
7. Click Next >>. The second of several consecutive sg/failover modules configuration screens
appear. Fill in the required fields, and accept or edit the default settings.
8. Click Next >> at the bottom of the screen to open the next screen in the series.
9. See the configuration summary below for an example of the NFS file system mount points, the
directories to export as well as the NFS export options.
10. After you complete all of the configuration screens, the Verify and submit configuration change
screen is displayed. Use the Check Configuration and Apply Configuration buttons at the
bottom of the screen to confirm and apply your changes.
Figure 14 Configuration summary page- sapnfs package
5.2 Infrastructure setup, pre-installation preparation (Phase 1) 57