Managing HP Serviceguard Extension for SAP for Linux, December 2013

1. Set up the package with both Serviceguard and SGeSAP modules.
2. Set up the package with only Serviceguard modules.
5.2.6.1 Intermediate synchronization and verification of mount points
The procedure for synchronizing mount points are as follows:
• Ensure that all the file system mount points for this package are created on all the cluster nodes
as mentioned in the prerequisites.
For example:
mkdir /usr/sap/C11/SCS40
Verification step(s):
Invoke cd /usr/sap/C11/SCS40 on all the nodes and test for availability.
5.2.6.2 SAP base package with Serviceguard and SGeSAP modules
At this stage any SGeSAP modules relevant to the SAP instance can be included into the base
package configuration.
5.2.6.2.1 Creating the package with the Serviceguard Manager
NOTE: To create a package you can use either Serviceguard Manager GUI or the CLI. This
section describes the GUI steps and the CLI steps are described in the “Creating the package
configuration file with the CLI” (page 63) section.
1. From the Serviceguard Manager Main page, click Configuration in the menu toolbar, and
then select Create a Modular Package from the drop down menu.
If Metrocluster is installed, a Create a Modular Package screen for selecting Metrocluster
appears. If you do not want to create a Metrocluster package, click no (default is yes). Click
Next >> and another Create a Modular Package screen appears.
2. If toolkits are installed, a Create a Modular Package screen for selecting toolkits appears.
3. Click yes following the question Do you want to use a toolkit?
4. Select the SGeSAP toolkit.
5. In the Select the SAP Components in the Package table, select the SAP Instances. This component
is incompatible with SAP NetWeaver Operation Resource (enqor).
Optionally for a database package, select the SAP Database Instance. For a combined
package, select both SAP Instances and SAP Database Instance. Other combinations are also
possible.
Figure 16 Toolkit selection screen
5.2 Infrastructure setup, pre-installation preparation (Phase 1) 61