Managing HP Serviceguard Extension for SAP for Linux, December 2013

6. Click Next >> and in the Select package type window, enter a package name. The Failover
package type is pre-selected and Multi-Node is disabled. The SGeSAP Package with SAP
Instances does not support Multi-Node.
7. Click Next >> at the bottom of the screen and another Create a Modular Package screen
appears with the following messages at the top of the screen:
The recommended modules have been preselected.
Choose additional modules for extra Serviceguard capabilities.
8. The modules in the Required Modules window are set by default and cannot be changed. In
the Select Modules window, you can select additional modules (or clear the default
recommended selections) by selecting the check box next to each module that you want to
add (or remove) from the package.
Click Reset to return to the default selections.
9. Click Next >> and another Create a Modular Package screens appears with the following
message:
Step 1 of X: Configure Failover module attributes (sg/failover), where X will vary, depending
on how many modules you selected.
There are two windows in this screen, Select Nodes and Specify Parameters. By default, nodes
and node order are pre-selected in the Select Nodes window. You can deselect nodes, or
change the node order, to accommodate your configuration requirements. Alternatively, you
can select Enable package to run on any node configured in the cluster (node order defined
by Serviceguard) and allow Serviceguard to define the node order.
To help in decision making, you can move the cursor over the configurable parameters, and
view the tool tips that provide information about the parameter.
10. Click Next >> and another Create a Modular Package screens appears.
Step 2 of X: Configure SGeSAP parameters global to all clustered SAP software
(sgesap/sap_global) .
Fill in the required fields and accept or edit the default settings.
Click Next >>. Another Create a Modular Package screen appears with the following message
at the top of the screen:
Step 3 of X: Configure SGeSAP SAP instance parameters (sgesap/sapinstance) .
Fill in the required fields, and accept or edit the default settings.
Click Next >> until the mandatory <SID> can be entered.
Figure 17 Configuration screen: SAP System ID
62 Clustering SAP Netweaver using SGeSAP packages