Managing HP Serviceguard Extension for SAP for Linux, December 2013

Choose additional modules for extra Serviceguard capabilities.
5. The modules in the Required Modules window are set by default and cannot be changed. In
the Select Modules window, you can select additional modules (or clear the default
recommended selections) by selecting the check box next to each module that you want to
add (or remove) from the package.
Figure 18 Module selection page
Click Reset at the bottom of the screen to return to the default selection.
6. After you are done with all the Create a Modular Package configuration screens, the Verify
and submit configuration change screen appears. Use the Check Configuration and Apply
Configuration buttons to confirm and apply your changes.
5.2.6.3.2 Creating the package configuration file with the CLI
NOTE: To create a package you can use either Serviceguard Manager GUI or the CLI. This
section describes CLI steps and the GUI steps are described in the “Creating the package with
Serviceguard Manger” (page 63) section.
1. Run any one of the following commands:
cmmakepkg –n <pkg> \
-m sg/volume_group \
-m sg/filesystem \
–m sg/package_ip <pkg>.config
or
cmmakepkg –n <pkg> \
-m sg/volume_group \
-m sg/filesystem \
–m sg/package_ip \
-m sg/service \
-m sg/generic_resource <pkg>.config
or
cmmakepkg –n <pkg> -m sg/all <pkg>.config
Add the required attributes for the SAP instance and database installation to the resulting
package configuration
64 Clustering SAP Netweaver using SGeSAP packages