Managing HP Serviceguard for Linux, Tenth Edition, September 2012

NOTE: cmapplyconf will fail if any node
defines a capacity and any package has
min_package_node as its failover_policy
(page 209) or automatic as its
failback_policy (page 210).
To specify more than one capacity for a node,
repeat these parameters for each capacity. You
can specify a maximum of four capacities per
cluster, unless you use the reserved
CAPACITY_NAME package_limit; in that case,
you can use only that capacity throughout the
cluster.
For all capacities other than package_limit,
the default weight for all packages is zero, though
you can specify a different default weight for any
capacity other than package_limit; see the
entry for WEIGHT_NAME and WEIGHT_DEFAULT
later in this list.
See “About Package Weights” (page 138) for more
information.
Can be changed while the cluster is running; will
trigger a warning if the change would cause a
running package to fail.
MEMBER_TIMEOUT The amount of time, in microseconds, after which
Serviceguard declares that the node has failed
and begins re-forming the cluster without this node.
Default value: 14 seconds (14,000,000
microseconds).
This value leads to a failover time of between
approximately 18 and 22 seconds, if you are
using a quorum server, or a Fiber Channel cluster
lock, or no cluster lock. Increasing the value to 25
seconds increases the failover time to between
approximately 29 and 39 seconds. The time will
increase by between 5 and 13 seconds if you are
you using a SCSI cluster lock or dual Fibre
Channel cluster lock).
Maximum supported value: 300 seconds
(300,000,000 microseconds).
114 Planning and Documenting an HA Cluster