HP Serviceguard for Linux Version A.11.18 Deployment Guide, August 2008

11
6. Click the “Next” button.
7. On the “Software download confirmation” page, click “Download Directly >>”.
At the time of publication, the version of the toolkit available was A.03.02-0. The downloaded file
for this version is named sglxtools-A.03.02-0.product.redhat.tar.
9. Linux Driver Kit for the Fibre Channel HBAs
Download the latest driver from Hewlett-Packard for the Fibre Channel host bus adapters ordered with
the MSA2000. The steps here are for the FC1243 card, which requires the latest “Driver Kit for
QLogic HBAs and QLogic mezzanine-based HBAs”. For the FC1242SR, look for the Driver Kit for
Emulex HBAs.
To download the kit:
1. Go to: http://www.hp.com.
2. Click “Software & Driver Downloads”.
3. Select “Download drivers and software (and firmware)”.
4. Enter product name, for example “FC1243”, in “for product:” box.
NOTE: Select the HBA Product ordered with your MSA2000, for example,
FC1243 (StorageWorks PCI-X 4 GBit Host Bus Adapter).
5. Click “>>”.
6. Select Operating System: Red Hat Enterprise Linux 5 Server (x86).
NOTE: Select Red Hat Enterprise Linux 5 Server (x86-64), if appropriate.
7. From the “Driver – Storage Controllers – FC HBA” section, locate the most recent “Linux
Driver Kit for HP Qlogic HBAs and mezzanine HBAs”.
8. Click “Download”.
At the time of publication, the most recent version was 8.01.07.25 (1 Nov 2007). The download file
for this version is named hp_qla2x00-2007-10-05.tar.gz.
10. HP Device Mapper Multipath Enablement Kit
Download the HP Device Mapper Multipath Enablement Kit. This kit is required to support multiple
paths from each server to the external storage device, the MSA2000.
To download the kit:
1. Go to http://www.hp.com/go/devicemapper.
2. Select Operating System, for example: Red Hat Enterprise Linux 5 Server (x86).
NOTE: Select Red Hat Enterprise Linux 5 Server (x86-64), if appropriate.
3. Click the “Download” button for the latest version of “Device Mapper Multipath Enablement
Kit for HP StorageWorks Disk Arrays”.
At the time of publication, the most recent version was v4.0.0 28 Feb 2008. The download file for
this version is named HPDMmultipath-4.0.0.tar.gz.
OS Installation
The OS installation must be performed on each server.
A monitor, keyboard, and mouse can be attached directly to the server as a console device or a
remote console can be used over the network via the HP iLO2 remote management port. To set up
the iLO2 browser-based management interface, refer to the HP Integrated Lights-Out 2 User Guide.