HP Serviceguard Toolkit for Enterprise DB PPAS for Linux User Guide Version A.12.00.00

ManualsBrandsHP ManualsSoftwareHP Serviceguard for Linux ProLiant Cluster

DescriptionAttributes

This variable specifies the user name of the EDB PPAS

administrator. The online modification of this attribute is not

supported.

DB_USER

For example: DB_USER ppas

Specify the email address to which you want the alert

notifications to be sent.

email_id

NOTE: By default, the email_id is commented. You must

remove the comment and provide the required email id to

receive the alert notifications.

This attribute specifies the monitor interval.MONITOR_INTERVAL

This is time interval in seconds, the monitoring script waits

between checks to make sure that EDB PPAS is running. The

default value is 30 seconds.

Specify the volume groups used by the EDB PPAS database

instance.

Specify the logical volume on which the file system is created.fs_name

For example: /dev/vgdata/vol1

Specify the mount point location for the EDB PPAS data directory.fs_directory

For example: /ppas

It is a type of the filesystem.fs_type

For example: ext3

Assign these attributes when the package is configured to

failover to another node. Also, when the package fails over

ip_address and ip_subnet

from one node to another node, client traffic IP must be moved

to the new node. Both the values must be defined in the

package.

5. Verify the validity of the EDB PPAS toolkit package configuration using the cmcheckconf

command.

For example:

cmcheckconf -P ppas_pkg.conf

For additional information about PPAS toolkit related errors, see “Cluster verification feature

for the EDB PPAS toolkit ” (page 6) section.

For additional information about package related errors, see the latest version of Managing

HP Serviceguard on Linux manual at http://www.hp.com/go/linux-serviceguard-docs.

6. If the cmcheckconf command does not report any errors, then run the cmapplyconf

command to add the package to the Serviceguard environment.

For example:

cmapplyconf -P ppas_pkg.conf

Run the cmviewcl command to verify the applied package.

NOTE: By default, the package switching is disabled.

7. Run the cmmodpkg command to enable the package switching.

This enables the EDB PPAS package to failover to the adaptive node after it fails on the primary

node.

For example:

Creating the EDB PPAS toolkit package 11