Building Disaster Recovery Serviceguard Solutions Using Continentalclusters for Linux B.01.00.00

0, the monitor does NOT send notifications to the syslog
file. When the parameter is set to 1, the monitor will send
notifications to the syslog file. If the parameter is not defined
(commented out), the default value is 0.
MON_NOTIFICATION_CONSOLE (Default = 0)
This parameter defines whether the monitor sends console
notifications. When the parameter is set to 0, the monitor
does NOT send console notifications. When the parameter
is set to 1, the monitor sends console notifications. If the
parameter is not defined (commented out), the default value
is 0.
AUTO_RESYNC This parameter defines the pre-defined resynchronization
actions that the monitor can perform when the package is
on the PVOL side and the monitor detects the Continuous
Access data replication link is down. If the variable is not
defined or commented, the default value of 0 is used.
Values:
0 — (Default) When the parameter is set to 0, the monitor
does not perform any resynchronization actions.
1 — When the parameter is set to 1 and the data replication
link is down, the monitor splits the remote BC (if configured)
and try to resynchronize the device. Until the
resynchronization starts, the monitor tries to resynchronize
every polling interval. After the device group is completely
resynchronized, the monitor resynchronizes the remote BC.
2 – When the parameter is set to 2 and the data replication
link is down, the monitor tries to perform resynchronization
if a file named MON_RESYNC exists in the package directory
(PKGDIR). The monitor does not perform any operations to
the remote BC (that is, split and resynchronize the remote
BC). Therefore, this setting is used when you want to manage
the remote BC.
Package Attributes for Continentalcluster with Continuous Access EVA
This appendix lists all the Package Attributes for Metrocluster with Continuous Access EVA P6000
for Linux. HP recommends that you use the default settings for most of these variables, so exercise
caution when modifying them:
CLUSTER_TYPE This parameter defines the clustering environment in which
the script is used. You must set this to metro if this is a
Metrocluster environment and continental if this is a
Continentalclusters environment. A type of metro is
supported only when the HP Metrocluster product is installed.
A type of continental is supported only when the HP
Continentalclusters product is installed.
DTS_PKG_DIR This variable contains the full path name of the package
directory.
DT_APPLICATION_STARTUP_POLICY This parameter defines the preferred policy to start the
application with respect to the state of the data in the local
volumes. It must be set to one of the following two policies:
Availability_Preferred: The user chooses this policy
when the application availability is preferred. Metrocluster
software allows the application to start if the data is
consistent even if the data is not current.
Package Attributes for Continentalcluster with Continuous Access EVA 69